&

德國MR CHEMIE顯像劑MR70產品描述
General appearance and composition:
Solvent removable developer for red and fluorescent penetrant testing form d and e according to EN ISO 3452-1
Water mixable
Dries quickly
Processing temperature -30 °C to +50 °C
Aerosol overhead sprayable

Relevant approvals and specifications
Sample testing acc. to EN ISO 3452-2 and EN ISO 3452-6
Low content of halogens and sulphur according to EN ISO 3452-2and ASME Code V, Section V, Article 6
In correspondence with Lloyd's Reg., Bureau Veritas, Det Norske Veritas,admitted by Framatome ANP
Produits et Matériaux Utilisables en Centrales (PMUC)
TLV 9017 01:2011-01

Application:
Remove tinder, rust and other contaminations from surface in a suitable manner. A
possible precleaner for removal of oils or fats is e.g. our remover MR79.
Apply MR Penetrant to the part to be tested either by spraying, brushing, flooding
or dipping. Allow to penetrate for at least 5 minutes.
Remove excess MR Penetrant from surface either using water or a clean lint-free
cloth lightly moistened with an MR? Remover.
Spray MR70 Developer from a distance of approx. 20 cm on the dry surface,
achieving a thin, uniform layer. Depending on the used penetrant, surface defects
will appear as red or fluorescent indications. Please note: If the developer layer is too thick tiny discontinuities will not appear through the developer.
When using a spray gun connected to compressed air it must be ensured that the
supplied air is free of water and fat.

Minimum shelf life:
Will keep for a minimum of 4 years, stored at room temperature

Pack sizes:
Aerosols, 500 ml (1 box contains 12 aerosols)
5 L, 30 L
Valve pen

愛澤工業(IZE_INDUSTRIESMR CHEMIE)*經銷、常用備件型號：
MR CHEMIE顯像劑MR70
MR CHEMIE顯像劑MR81
MR CHEMIE顯像劑MR703W
MR CHEMIE顯像劑MR703WK

上一篇：愛澤工業2018年5月部分到貨產品專題及庫存 MINARIK電機調速箱

下一篇：HYPERTAC連接器LPNA/LPPA/LPRA/LPNA系列

返回列表>>

福利视频导航网-福利视频导航网站-福利视频导航网址-福利视频导航页-福利视频导航在线-福利视频导航在线观看